Wheelie Good Wall Mount – Installation Guide

​

Thank you for your purchase of the Wheelie Good Wall Mount!

This sleek, minimalist design securely holds two road, gravel, or mountain bike wheels while keeping your space clean and organized.

​

Space Requirements:
Each holder requires a minimum of 30” of vertical and horizontal wall space.

​

Important:
Mounting into a wall stud (behind sheetrock or similar surface) is the strongest and most secure installation method.

​

Installation Instructions

Option 1: Mounting to a Stud (Recommended)

1. Remove the blue tape from the back of the mount and place it on the wall over a stud.

2. Ensure the tape is level (straight).

3. Use the marked holes on the tape as a guide to drill pilot holes.

4. Position the mount over the tape, aligning with the pilot holes.

5. Secure the mount by driving screws directly into the stud.

​

Option 2: Mounting to Sheetrock (Drywall)

⚠️ Wall anchors are REQUIRED when not mounting to a stud.

1. Remove the blue tape from the back of the mount and place it in your desired location.

2. Ensure the tape is level.

3. Mark the hole locations and drill pilot holes (use an appropriately sized drill bit for the included anchors).

4. Insert the blue wall anchors into the holes until they are flush with the wall (a light tap with a hammer may be needed).

5. Align the mount and drive the screws into the anchors.​

​

Weight & Safety

• Stud Mounting: Tested to hold up to 30 lbs (recommended method)

• Drywall with Anchors: Suitable for standard road, gravel, or mountain bike wheels

✔️ For maximum safety and durability, mounting into a stud is strongly recommended.

​

If you have any questions, feel free to reach out:

📧 shamrockwood315@gmail.com

Thank you for supporting Shamrock Workshop!